[suman]

Discuss about how to prepare for bsnl tta exam here. Welcome to Courses.ind.in and this page is for how to prepare for bsnl tta exam discussion. If you are looking for information on how to prepare for bsnl tta exam then ask your question is as much details as possible in the “Reply” box provided below. The more detailed your question will be, the more easy will it be for our experts to answers your query. And if you have any updated or latest information on how to prepare for bsnl tta exam, then please share you knowledge with our experts in the “Reply” box below. Your reply will be published here and your knowledge can help many people. Thanks for stopping by at Courses.ind.in. Please visit again.

Would you please get the exam paper of BSNL TTA post, so that I can solve it and prepare hard for the exam?

[Vishal Kotkar]

Feel free I will provide you BSNL TTA post exam paper, so that it would be easy for you to prepare hard.

Here is the exam paper

Question .1 A house served by a 220V supply light, is protected by a 9-Ampere fuse. The maximum number of 60 W bulbs in parallel that can be turned on is
(a) 11
(b) 33
(c) 22
(d) 44
Answer: B

Question.2 A capacitor of 1 Q.4 μF initially charged to 10 V is connected across an ideal inductor of 0.1 mH. The maximum current in the circuit is
(a) 0.5 A
(b) 1 A
(c) 1.5 A
(d) 2 A
Answer: B

Question.3 An n-channel JFET has I Q.2 DSS = 1 μA & VP =–5V. The maximum trans conductance is
(a) gm = 0.4 milli mho
(b) gm = 0.04milli mho
(c) gm = 0.04 mho
(d) gm = 0.4 millimilli mho
Answer: D

Question.4 Silicon has a preference in IC technology because Q.5
(a) it is an indirect semiconductor
(b) it is a covalent semiconductor
(c) it is an elemental semiconductor
(d) of the availability of nature oxide SiO
Answer: D

Question.5 An analog voltmeter has a sensitivity of 10kΩ/volt. The galvanometer used in constructing the instrument will produce a full scale deflection when the current passed through it is
(a) 10 mA
(b) 20 mA
(c) 50 mA
(d) 100 μA
Answer: D

Question.6 The base to base resistance of a UJT is 6 K Ohm when the emitter current is zero. If B1 R = 3.6 K Ohm, the intrinsic stand off ratio is
(a) n = 0.66
(b) n = 0.6
(c) n = 6.0
(d) n = 3.6
Answer: B

Question.7 Transient signals can be observed using
(a) storage oscillocope
(b) sampling oscilloscope
(c) wave analyzer
(d) spectrum analayzer
Answer: A

Question.8 A power diode has lightly doped n type substrate sandwiched between heavily doped p and n regions
(a) to increase reverse breakdown voltage
(b) to reduce ohmic loss under forward bias
(c) to decrease switching time of the power diode
(d) to improve transient behaviour of the diode
Answer: D

Question.9 A P-controller is used to adjust the outer level of a tank in range of (0-10)m. The desired level is 5 m. The controller should fully close the valve, if level rises to 5.5 m and it should fully open the valve, if level falls to 4.5 m. What should be the % P-band?
(a) 1
(b) 5
(c) 7
(d) 10
Answer: D

Question.10 Some system architects do not find RISC instruction repertoire to be cost-effective because it
(a) result in large increase in programme size
(b) result in complex structure of microcode
(c) has been observed that an average compiler does not employ more than a limited subset of available instructions
(d) results in complex decoding of opcode filed resulting in longer execution time
Answer: A

Question.11 What addressing mode is used in the instruction RET?
(a) Direct
(b) Immediate
(c) Implicit
(d) Register-indirect
Answer: D

Question.12 The speed of an audio cassette tape in a cassette player is 5cm/ sec. If the maximum frequency that needs to be recorded is 20 KHz, the minimum spatial wavelength on the tape is
(a) 40 μm
(b) 25 μm
(c) 4 μm
(d) 2.5 μm
Answer: D

Question.13 In order to generate electron-hole pairs, the maximum wavelength of radiation for Silicon (Band gap = 1.1 eV) is
(a) 1.88 μm
(b) 1.68 μm
(c) 1.13 μm
(d) 1.54 μm
Answer: C

Question.14 Which of the following pairs of crystal structure possesses the same atomic packing density?
(a) simple cubic & body centred cubic
(b) body centred cubic & face centred cubic
(c) face centered cubic & hexagonal close packed
(d) body centred cubic & hexagonal close packed
Answer: C

Question.15 In a power transformer, the fundamental frequency of the hum arising due to magnetostriction is
(a) equal to the line frequecy
(b) double the line frequency
(c) 4 times the line frequency
(d) not related to the line frequency
Answer: B

Question.16 The polar bonds existing in III-V compound semicondutor, may be considered as equivalent to
(a) 1 ionic bond and 3 covalent bonds
(b) 1 ionic bond and 4 covalent bonds
(c) 2 ionic bonds and 2 covalent bonds
(d) 2 ionic bonds and 4 covalent bonds
Answer: A

Question.17 In a regenerative braking, which of the following is generally true?
(a) Back e.m.f. in the motor exceeds the applied voltage
(b) Back e.m.f. is less than the applied voltage
(c) Kinetic energy of the motor is dissipated in a resistance
(d) Kinetic energy of the motor is dissipated through free wheeling diode across the motor
Answer: A

Question.18 To distinguish between signals having very close values, we need
an instrument with
(a) high accuracy
(b) high resolution
(c) high sensitivity
(d) high linearity
Answer: B

Question.19 The trace on an oscilloscope continually moves to the right of the screen when
(a) the sweep is triggered.
(b) the sweep period is larger than the signal period.
(c) the sweep period is smaller than the signal period.
(d) there is no weep.
Answer: B

Question.20 An optical fiber cable laid underground has developed a discontinuity at a distance d from the source end. The fault can be located using the instrument
(a) Optical spectrum Analyzer (OSA)
(b) Optical Time Domain Reflectometer (OTDR)
(c) Optical Power Meter (OPM)
(d) Laser Diffractometer (LD)
Answer: B